Bytwo B202new Flash File 6531E (Stock ROM)

You want flashing your Bytwo B202new keypad phone and looking for the desired flash file? Then this article may be helpful for you. So read the whole post carefully, because I have shared the download link of all the equipment including flash file, USB driver, flash tool to flash the Winstar W805 mobile phone. Also discussed the flushing procedure step by step.

 

The Bytwo B202new Stock Firmware ROM is using to solve Full Flash, Dead Recovery, Pin Remove of your Winstar device. The flash file currently comes in a zip package and we are publishing below this firmware all details. You first check the details before download the firmware file. Because you will facing any problems for which we will not be responsible in any way.

 

 

 

Download Bytwo B202new Flash File Stock ROM

Here we are providing 100% tested firmware flash file for Bytwo B202new SC6531E. keypad mobile device. So, you can download and install the Stock ROM without any manufacturing issue.

 

 

 

 

 

Need Also:

Symphony B26 Flash File SC6531E

 

 

How to Flash

Before flashing the Stock ROM on your Bytwo B202new, you should download the firmware stock rom. Then download and install the USB Drivers and Flash tool on the PC as well. Once you’re done with these, you can proceed to the steps below. Take a complete backup of your device after start flashing process.

 

Steps to Flash Bytwo B202new Flash File

Following below steps to flash your Bytwo B202new mobile phone using CM2/Miracle or other’s flash tools. Also We have shared a short tutorial of Miracle Thunder Free Carck Tool.

 

Method: 1

1. Download and extract the flash file on your computer.
2. Install the USB Driver on your computer.
3. Click to  tool on your PC screen
4. Select SPD
5. Choose SP 6631E
6. Add file on the tool
7. Click the Start button.
8. Connect your device to computer via USB cable
9. Insert battery in mobile.
10. That’s ok! Now start your flash process.

 

 

Method 2: (If you have a pac file, So that following the tutorial)

 

1: First download SPD Flash tools from above link and extract it inside a Folder.

2: And then download Firmware for Your phone from above link and extract it inside a folder.

3: After that install latest SPD USB Driver on your PC.

4: Double click to Run Flash tool.exe file from tool folder and load pac File under firmware.

5: And then click Start button

6. As soon as connect your Switched off device to PC via USB cable. Until Press and Hold Volume up or Volume down key.

6: And in the last wait for Success Done.

7: That’s it! You have successfully Flashed your Phone.

That’s it, guys. We hope that you’ve installed the firmware on your device successfully.