3000+ Bar Phone FirmwareGet Update for Click

iPhone 11 Pro Max Clone Flash File MT6580 Firmware Stock ROM

If you want install Firmware Stock ROM on your iPhone 11 Pro Max Clone smartphone and looking for the desired Stock Firmware? Then this article may be helpful for you. So read the whole post carefully, because I have shared the direct download link of all the equipment including firmware , USB driver, flash tool to flash the iPhone Clone android phone. Also discussed the flashing procedure step by step.

iphone-11-pro-max-clone





The iPhone Clone Firmware Stock ROM is using to solve Full Flash, Dead Recovery, FRP Remove,Hang logo etc of your iPhone device. Before extracting the Stock Firmware comes in a zip package and we are publishing firmware details section this firmware all information. You first check the info before download the stock firmware. Because are you facing any manufacturing/partition for which we will not be responsible.

 

Download iPhone 11 Pro Max Clone Stock ROM

Here we are providing 100% tested flash file firmware for iPhone clone android smartphone. So, you can download and install the Stock ROM without any manufacturing issue.

 

Software details:

  • File Name: iPhone 11 Pro Max Clone (alps)
  • Processor: MT6580
  • OS Version: Android 6.0
  • File Type: Scetter
  • Supported Tool: SP Flash Tool
  • File Size: 1GB

 




 

 

 

How to Flash

Before flashing the Stock ROM on your iPhone Clone, you should download the iPhone 11 Pro Max firmware stock rom. After download and install the USB Drivers and flash tool on the PC. Once you are done with these, you can proceed to the below instruction. Take a full backup file of your iPhone smartphone device.

 

Step to Flash Your iPhone 11 Pro Max Clone

Follow to the below steps from flash your iphone android device. We have flashing the iphone device using free SP Flash Tool windows version.

1: First download SP Flash tools from above link and extract it inside a Folder.

2: And then download Firmware for Your phone from above link and extract it inside a folder.

3: After that install latest MTK USB Driver on your PC.

4: After that Run Flash tool.exe file from tool folder and load Scatter File under firmware.

5: And then click Download button

6. As soon as connect your Switched off device to PC via USB cable. Until Press and Hold Volume up or Volume down key.

7: And in the last wait for Green Ring of Success Done.

8: That’s it! You have successfully Flashed your Phone.

That’s it, guys. We hope that you have installed the iphone device stock firmware.

One Comment

Add a Comment

Your email address will not be published. Required fields are marked *