You want flashing your Lava C22 keypad phone and looking for the desired flash file? Then this article may be helpful for you. So read the whole post carefully, because I have shared the download link of all the equipment including flash file, USB driver, flash tool to flash the Lava C22 mobile phone. Also discussed the flushing procedure step by step.
The Lava C22 Stock Firmware ROM is using to solve Full Flash, Dead Recovery, Pin Remove of your Proton device. The flash file currently comes in a zip package and we are publishing below this firmware all details. You first check the details before download the firmware file. Because you will facing any problems for which we will not be responsible in any way.
Download Lava C22 Flash File (Firmware)
File Name: Lava C22
Processor: SC6531E
File Type: Bin
File Size: 4MB
How to Flash
Before flashing the Stock ROM on your Lava C22 SC6531E device, you should download the firmware stock rom. Then download and install the USB Drivers and flash tool on the PC as well. Once you’re done with these, you can proceed to the steps below. Take a complete backup of your device after start flashing process.
Download Latest SCR USB Driver
Download SC6531E Flash Tool Crack
Step to Flash Your Lava C22
Following below steps to flash your Lava C22 mobile phone using CM2/Miracle or other’s flash tools. Also We have shared a short tutorial of Miracle Thunder Tool.
- Download and extract the flash file on your computer.
- Install the USB Driver on your computer.
- Lunch tool on your PC screen
- Select SPD
- Choose SP 6631E
- Add file on the tool
- Click the Start button.
- Connect your device to computer via USB cable
- Insert battery in mobile.
- That’s ok! Now start your flash process.
[Method 2] Flash With SP Flash Tool using Pac File:
- First download SPD Flash tools from above link and extract it inside a Folder.
- And then download Firmware for Your phone from above link and extract it inside a folder.
- After that install latest SPD USB Driver on your PC.
- After that Run Flash tool.exe file from tool folder and load pac File under firmware.
- And then click Start button
- As soon as connect your Switched off device to PC via USB cable. Until Press and Hold Volume up or Volume down key.
- And in the last wait for Success Done.
- That’s it! You have successfully Flashed your Phone.
That’s it, guys. We hope that you’ve installed the firmware on your device successfully.