You want flashing your Symphony G100 Flash File smartphone and looking for the desired flash file firmware? Then this article may be helpful for you. So read the whole post carefully, because I have shared the download link of all the equipment including flash file, USB driver, flash tool to flash the Symphony G100 Flash File android device. Also discussed the flushing procedure step by step.
The Symphony G100 Flash File Flash File (Stock Firmware ROM) is using to solve Full Flash, Dead Recovery, FRP Remove,Downgrade, Upgrade of your Symphony Android device. The flash file currently comes in a zip package and we are publishing below this firmware all details. You first check the details before download the firmware file. Because you will facing any problems for which we will not be responsible in any way.
Download Symphony G100 Flash File Stock ROM
Here we are providing 100% tested firmware for Symphony G100. So, you can download and install the Stock ROM without any manufacturing issue.
File Name: GP_G100_HW1_V11_20180907
OS Version: Android 8.1
Processor: MT6739
File Type: Scatter
Status: Tested
File Size: 687MB
Download_Symphony_GP_G100_HW1_V7_20180703
Download_Symphony_GP_G100_HW1_V11_20180907
Need Also: Symphony G10 Flash File
How to Flash
Before flashing the Stock ROM on your Symphony G100 Flash File, you should download the firmware stock rom. Then download and install the USB Drivers and flash tool on the PC as well. Once you’re done with these, you can proceed to the steps below. Take a complete backup of your device after start flashing process.
Pre-requisite:
- You need a PC/Laptop
- Download SP Flash Tool
- Download and install MediaTek USB driver on your PC
- Minimum 70%+ charge your phone.
- Need a better media USB cable
Step to Flash Symphony G100
Following below steps to install Stock ROM your iPhone Clone device using CM2/Miracle or other’s flash tools. Also We have shared a short tutorial of SP Flash Tool.
1: First download SP Flash tools from above link and extract it inside a Folder.
2: And then download Firmware for Your phone from above link and extract it inside a folder.
3: After that install latest MTK USB Driver on your PC.
4: After that Run Flash tool.exe file from tool folder and load Scatter File under firmware.
5: And then click Download button
6. As soon as connect your Switched off device to PC via USB cable. Until Press and Hold Volume up or Volume down key.
7: And in the last wait for Green Ring of Success Done.
8: That’s it! You have successfully Flashed your Phone.
That’s it, guys. We hope that you’ve installed the firmware on your device successfully.