You want flashing your Symphony i12 Flash File on android phone and looking for the desired Stock ROM? Then this article may be helpful for you. So read the whole post carefully, because I have shared the download link of all the equipment including flash file, USB driver, flash tool to flash the Proton RG02 mobile phone. Also discussed the flushing procedure step by step.
The Symphony i12 Flash File Stock Firmware ROM is using to solve Full Flash, Dead Recovery, Pin Remove of your Proton device. The flash file currently comes in a zip package and we are publishing below this firmware all details. You first check the details before download the firmware file. Because you will facing any problems for which we will not be responsible in any way.
Download Symphony i12 Flash File Firmware
Here we are providing 100% tested firmware flash file for Symphony android smartphone. So, you can download and install the Stock ROM without any manufacturing issue.
Software details:
File Name: Symphony i12
Processor: SP7731E
OS Ver: Android 10
Supported Tool: SPD Flash Tool
File Type: Pac File
File Size: 1.2GB
Need Also: Symphony G10 Flash File
How to Flash
Before flashing the Stock ROM on your Symphony i12 smartphone, you should download the firmware stock rom. Then download and install the USB Drivers and flash tool on the PC as well. Once you’re done with these, you can proceed to the steps below. Take a complete backup of your device after start flashing process.
Step to Flash Your Symphony i12
Following below steps to flash your Symphony i12 mobile phone using CM2/Miracle or other’s flash tools. Also We have shared a short tutorial of SPD Flash Tool.
1: First download SPD Flash tools from above link and extract it inside a Folder.
2: And then download Firmware for Your phone from above link and extract it inside a folder.
3: After that install latest SPD USB Driver on your PC.
4: After that Run Flash tool.exe file from tool folder and load pac File under firmware.
5: And then click Start button
6. As soon as connect your Switched off device to PC via USB cable. Until Press and Hold Volume up or Volume down key.
7: And in the last wait for Success Done.
That’s it, guys. We hope that you’ve installed the firmware on your device successfully.
