3000+ Bar Phone FirmwareGet Update for Click

Symphony i30 Flash File SP7731E (Firmware Stock ROM)

You want flashing your Symphony i30 Android phone and looking for the desired flash file? Then this article may be helpful for you. So read the whole post carefully, because I have shared the download link of all the equipment including Symphony i30 flash file, USB driver, flash tool to flash the Symphony i30 smartphone. Also discussed the flashing procedure step by step.


The Symphony i30 Stock Firmware ROM is using to solve Full Flash, Dead Recovery, Pin Remove of your Proton device. The flash file currently comes in a zip package and we are publishing below this firmware all details. You first check the details before download the firmware file. Because you will facing any problems for which we will not be responsible in any way.

Why Need Symphony i30 Flash File?

The Flash Firmware or a Flash File is official software that is designed by the OEM manufacturer for a particular device. This file is required to fix any software related issue on your Symphony i30. If you are facing any problem with your smartphone device, your final attempt will be to re-download/install the firmware. This way, you can restore your device back to firmware. So, you can download the firmware without any issue.

Download Symphony i30 Flash File (Firmware)

Here, we are added direct download link to Symphony G10 firmware flash files. So that you can easily download your desired firmware file

How to Flash

Before flashing the Stock ROM on your Symphony i30, you should download the firmware stock rom. Then download and install the USB Drivers and flash tool on the PC as well. Once you’re done with these, you can proceed to the steps below. Take a complete backup of your device after start flashing process.

Step to Flash Symphony i30

Following below steps to flash your Symphony i30 Android smartphone using CM2/Miracle or other’s flash tools. Also We have shared a short tutorial of SPD Flash Tool.

1: First download SPD Flash tools from above link and extract it inside a Folder.

2: And then download Firmware for Your phone from above link and extract it inside a folder.

3: After that install latest SPD USB Driver on your PC.

4: After that Run Flash tool.exe file from tool folder and load pac File under firmware.

5: And then click Start button

6: As soon as connect your Switched off device to PC via USB cable. Until Press and Hold Volume up or Volume down key.

7: And in the last wait for Success Done.

8: That’s it! You have successfully Flashed your Phone.

That’s it, guys. We hope that you’ve installed the firmware on your device successfully.

Add a Comment

Your email address will not be published. Required fields are marked *