You want flashing your Walton P15 feature phone and looking for the desired flash file? Then this article may be helpful for you. So read the whole post carefully, because I have shared the download link of all the equipment including Walton P15 flash file, USB driver and flash tool. Also discussed the flashing procedure step by step.
The Walton P15 Stock Firmware ROM is using to solve Full Flash, Dead Recovery, Pin Remove of your Walton feature device. The Stock firmware currently comes in a rar package and we are publishing below this mobile phone software and hardware related all details. You first check the details before download the firmware file. Because, you will facing any problems for which “Gsmbuzz.com” will not be responsible in any way.
Download Walton P15 Flash File Stock ROM
Here we are providing 100% tested firmware flash file for Walton P15 SC6531E. So, you can download the latest flash file firmware without any manufacturing issue.
Releated: Walton “MM23 Firmware
How to Flash
Before flashing the Stock ROM on your Walton P15, you should download the firmware stock rom. Once you are complete with these, you can proceed to the below steps. Take a complete backup of your device after start flashing process.
Steps to Flash Walton Walton P15 Flash File
Follow the below guide to flash your Walton P15 keypad mobile device using CM2/Miracle or other’s flash tools. Also We have shared a easy guideline of Miracle Thunder Tool Crack.
1. Download and extract the flash file on your windows PC.
2. Install the USB Driver on your PC
3. Click to tool on your PC screen
4. Select SPD
5. Choose 6631 SP
6. Add file on the tool
7. Click the Start button.
8. Connected your mobile to PC via USB cable
9. Insert battery in mobile.
10. That’s ok! Now start your flash process.
Method 2: (If you have a pac file, So that following the tutorial)
1: First download SPD Flash tools from above link and extract it inside a Folder.
2: Then download Firmware for your phone from above link and extract it inside a folder.
3: After that install latest SPD USB Driver on your PC.
4: Double click to Run Flash tool.exe file from tool folder and load pac File under firmware.
5: And then click Start button
6. As soon as connect your Switched off device to PC via USB cable. Until Press and Hold Volume up or Volume down key.
6: And in the last wait for Success Done.
7: That’s it! You have successfully Flashed your Phone.
That’s it, guys. We hope that you’ve installed the firmware on your device successfully.